Title.jpg (30510 bytes)

Physical Parameters Mechanical Dimensions
AR : COMMON ANODE RED Face Length : 19 mm
CR : COMMON CATHODE RED Face Width : 10 mm
AG : COMMON ANODE GREEN Height : 6 mm
CG : COMMON CATHODE GREEN Pin Spacing : 2.5 mm
Row Spacing : 7.6 mm
  
diagram118.jpg (10441 bytes)
  
Colour Voltage
(in V)
min   avg  max		 Current
(in mA)
  min  avg   max		 Power Diss.
(in mW)
min   avg   max		 Peak Wavelength
(in nM)		 Typical Intensity
(in mcd at 10mA)
Red
1.7 2 3
5 10 30
9 20 90

660

9
Green
1.7 2 3
5 10 30
9 20 90

570

7
 

IE 118  CR/CG

IE 118  CR/CG
Pin Connection Pin Connection
1 COM  Cathode 6 COM Cathode
2 F  Anode 7 RDP  Anode
3 G  Anode 8 C  Cathode
4 E  Anode 9 B  Anode
5 D  Anode 10 A  Anode

ie118cathode.jpg (8669 bytes)

IE 118  AR/AG

IE 118  AR/AG
Pin Connection Pin Connection
1 A  Cathode 8 D  Cathode
2 F  Cathode 9 RDP  Cathode
3 COM  Anode 10 C  Cathode
4 No Pin 11 F  Cathode
5 No Pin 12 No Pin
6 LDP Cathode 13 B Anode
7 No Connection       

ie118annode.jpg (9491 bytes)
     
1. For uniform brightness, equal current (10-20 mA) must be given for all segments with 2 volts supply. Choose appropriate resistor for uniform brightness ( R= { Vs - Vf } / IF) .
2. For cleaning, IP alcohol can be used but should not be in contact with the surface for more than 1 minute.
3. Do not bend the pins after soldering. If required, it may be done before soldering only.
4. Soldering rod should be kept away from the body of the display.